Kramer Electronics VS-44HN - Manual (Page 19)

16 VS-44HN - Connecting to the VS-44HN
This type of connection is recommended for identifying the VS-44HN
with the factory configured default IP address.
After connecting the VS-44HN to the Ethernet port, configure your PC as follows:
1. Click Start > Control Panel > Network and Sharing Center.
2. Click Change Adapter Settings.
3. Highlight the network adapter you want to use to connect to the device and
click Change settings of this connection.
The Local Area Connection Properties window for the selected network
adapter appears as shown in Figure 5 .
Figure 5: Local Area Connection Properties Window
4. Highlight either Internet Protocol Version 6 (TCP/IPv6) or Internet
Protocol Version 4 (TCP/IPv4) depending on the requirements of your IT
system.
i