Kramer Electronics VS-41HC - Manual (Page 13)

10 VS-41HC - Setting the EDID
5 Setting the EDID
You can acquire or change the EDID (see Section 5.1 ) or reset the machine to the
default EDID (see Section 5.2 ).
5.1 Acquiring / Changing the EDID
You can work with the default EDID or acquire or change an EDID via the
connected output. Use the EDID button to acquire the output EDID information.
To acquire or change the EDID of a new output display:
1. Connect the power supply.
2. Connect the new output display device.
3. Press the EDID button.
The INPUT buttons blink in sequence until the EDID is acquired.
5.2 Resetting the Default EDID
To reset the default EDID, disconnect the output and repeat the steps in Section
5.1 .