Kramer Electronics VP-300THD - Manual (Page 9)

Connecting the VP-300THD
7
2. On the TP-120 XGA Line Receiver, connect the XGA OUT 15-pin HD
connector to the XGA / HD acceptor (for example, a display).
3. Connect the LINE OUT RJ-45 connector on the VP-300THD to the LINE
IN RJ-45 connector on the TP-120, via UTP cabling (with a range of more
than 300ft (more than 100 meters)), see section 3.2 .
4. Connect the 12V DC power adapter to the power socket on the
VP-300THD
, and plug the adapter into the mains electricity socket.
Similarly, connect the other 12V DC power adapter to the power socket on
the TP-120, and plug that adapter into the mains electricity socket.
5. On the VP-300THD, if required:
ƒ Set the ID BIT switch to ON
ƒ Set the VS and HS switches 1 on the underside
6. On the TP-120, if required:
ƒ Adjust 2 the video output signal level and/or cable compensation
equalization level
ƒ Set the H SYNC and V SYNC switches 3 , on the underside
Figure 3: Connecting the VP-300THD
1 By default, both switches are set to the left (to NORMAL) to retain the VS and HS polarity
2 Use a screwdriver to carefully rotate the trimmer, adjusting the appropriate level
3 By default, both switches are set down (for normal V SYNC and H SYNC polarity)
LINE
OUT
OUTPUT
2
VP-300THD
1:2
XGA/HD
/CAT5
Transmitter
DA
OUTPUT
1
TP-120
VP-300THD
Projector
Display
Display
VGA
VGA
Computer
Graphics Source
VGA
VGA
CAT
5