Kramer Electronics VP-300THD - Manual (Page 4)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Getting Started
2
2.1 Quick Start
This quick start chart summarizes the basic setup and operation steps.
Step 1: Connect the input and the outputs
m Set the polarity and the ID bit using the underside switches m Set the polarity and the ID bit using the underside switches
Step 2: Connect the power
Step 3: If required:
1
1
2
2
3
3
3
Connect the input
Connect the outputs
Connect the CAT 5 cable between the
transmitter (VP-300THD) and the
receiver (TP-120)
Connect the input
Connect the outputs
Connect the CAT 5 cable between the
transmitter (VP-300THD) and the
receiver (TP-120)
LINE
OUT
OUTPUT
2
VP-300THD
1:2
XGA/HD
/CAT5
Transmitter
DA
OUTPUT
1
TP-120
VP-300THD
Projector
Display
Display
VGA
VGA
Computer
Graphics Source
VGA
VGA
CAT
5