beautypg.com

Festo Линейные модули HMP User Manual

Page 7

background image

Wire the electrical connections as fol-
lows (see Fig. 8 and 9):

1. Connect the terminal strip

5

for the

sensors (check polarity of the sensors).

2. Disconnect the plug for the common

cable

7

from the plug base

8

.

3. Remove approx. 6 mm of insulation

from the cable core.

4. Connect the plug and insert it again.

Do not squeeze the sensor cables.

5. Fix the common cable at the metal sup-

port with a cable binder (strain relief).

Fasten the end cover with the
screws supplied.

Verkabeln Sie die elektrischen An-
schlüsse wie folgt (siehe Bild 8 u. 9):

1. Sensoren an der Klemmleiste

5

verka-

beln (auf Polung der Sensoren achten)

2. Stecker für Sammelkabel

7

vom

Steckersockel

8

abziehen.

3. Adern abisolieren (Abisolierlänge:

ca. 6 mm).

4. Stecker verkabeln und wieder auf-

stecken. Sensoradern dabei nicht quet-
schen.

5. Sammelkabel mit Kabelbinder am

Metallträger fixieren (Zugentlastung).

Befestigen Sie den Abschlußdeckel
mit den beiliegenden Schrauben.

Bild 8/Fig. 8

Bild 9/Fig. 9

Bild 10/Fig. 10

0001a

D/GB 7

This manual is related to the following products: