Chemglass CG-1993-T - Manual (Page 9)

4.2 Display
Figure 5
Characters Descriptions
Temp & °C
Displays temperature when the heating
function is switched ON.
Stir
Displays stirring speed when the stirring
function is switched ON.
Hot
Displays HOT warning if the plate
temperature is above 50°C after
switching OFF the heating function.
Timer Timer parameter when the timer
function is switched ON.
Probe
Display when using external probe.
Remote
Display when using remote control.
Rated value/Real
value
Display values in when heating or
stirring or timer function is switched
ON.
Table 3
Note：
If both heating and stirring functions have been
started at the same time, heat display always has
higher priority. If in this case speed is changed via
the stirring knob, it displays stirring speed and
reverts to temperature after 5 seconds.
5 Trial Run
• Make sure the required operated voltage and power
supply voltage match.
• Ensure the socket is properly grounded.
• Plug in the power cable, ensure the power is on and
begin initializing.
• Add the medium into the vessel with an appropriate
stirring bar.
• Place vessel on the work plate.