Chemglass CG-1993-T - Manual (Page 5)

Do not use damaged components. Safe operation is only
guaranteed with the accessories listed in the “Accessories”
section. Accessories must be securely attached to the
device and must be removed when not in use. Always
disconnect the power before fitting accessories.
• When using the external temperature sensor, the tip of the
measuring sensor must be at least 5-10mm from vessel’s
bottom and wall.
• The instrument can only be fully disconnected from the
main power supply by turning off the main or disconnecting
the plug.
• The voltage stated on the label must correspond to the
main power supply.
• Ensure that the main power supply cable does not touch
the hotplate. Do not cover the device.
• The instrument must only be operated by adults.
• Keep away from high magnetic fields.
2 Proper Use
The instrument is designed for mixing and/or heating
liquids in laboratories:
• Do not use more than 2000 meters above sea level
• Temperature between 0℃and 40℃
• Installation Type: Product is designed to connect the
indoor outlet, where voltage fluctuation is not more
than ±10% compared with normal.
• Observe the minimum distances between multiple
units, and distances to the rear wall and above the
assembly (min. 100 mm).
Figure 1
This device is not suitable for using in residential areas or
other constraints mentioned in Chapter 1.
>100mm
>100mm
3