Muxlab HDMI 4×4 Matrix Switch Kit, HDBT, PoE - Manual (Page 29)

© MuxLab Inc. HDMI 4x4 Matrix Switch, HDBT Installation Guide
Page 29
In the Administration tab (Figure 25), the user can modify passwords for users and (if
applicable) administrators, select and install new firmware, restore or backup data and
reset the unit to factory settings.
Figure 25: Setup Submenu – Administration Tab
To implement password modifications, an administrator makes changes to the
Administrator Password and/or the User Password, and then clicks on the
corresponding Save button. Regular users can only make changes to the User
Password.
The file for upgrading the firmware must be located on the PC. The user clicks on
Choose File to browse for the file, and then installs it by clicking on Upload.
It is recommended, before upgrading to a new firmware to do a Backup of all the data
configurations, such as port names, presets, alarms, network settings etc. And then
Restore these data after the firmware upgrade.
To do so, click on the “Backup” button and you will be asked to save the data
configuration file. Then perform the firmware upgrade. After the unit is upgraded, go
to the Administration tab, in the “Restore data” section, select the data configuration
file previously saved on you PC, then click on the “Restore” button.
Finally, you can reset the unit and apply all the factory settings by clicking on the
“Reset” button.