SawStop T-Glide Fence System - Manual (Page 9)

If there is any misalignment, you can correct it by turning one of the two parallelism adjustment screws in the
vertical edge of the fence glide bracket. See Fig. 9.
The next step is to adjust the face plates to be perpendicular to the table top. The angle between the face
plates and the table is set by the two plastic leveling screws in the horizontal edge of the glide bracket. See
Fig. 12.
5. Fence Adjustments: Although the fence is factory-adjusted to nominal settings, it is usually necessary to
make final adjustments once your rails and extension table have been installed on the saw.
The first step is to align the face plates to be parallel to the miter slots. Begin by sliding the fence along the
tube until the left face plate is flush with the right edge of the right miter slot. Lock the fence handle and check
that the face plate is flush with the miter slot edge along its whole length. See Fig. 11. You can check this either
visually or by running your finger along the face plate and miter slot edge.
page 7
Fig. 11
Fig. 12