beautypg.com

SawStop T-Glide Fence System User Manual

Page 5

background image

Each support leg is mounted to the underside of the extension table using two angled brackets. Align the two

holes in the support leg to the two holes in the brackets. Put one of the M10 x 45 hex head bolts through each

hole in the leg and brackets. Thread an M10 lock nut on the end of the bolt and tighten with a 17 mm wrench.

See Fig. 4. You will need to hold the head of the hex bolt with another 17 mm wrench to tighten the lock nut.

Next, mount the brackets to the underside of the extension table using the M4 x 16 mm wood screws provided.

The underside of the extension table is pre-drilled to receive the screws. Be careful not to overtighten these

wood screws because you may strip the threads in the wood.

The next step of the assembly is easiest with two people. Position the extension table between the

front and rear rails. The support leg(s) should be at the far end of the rails, away from the saw. Install

M8 x 40 countersunk socket head bolts through the front rail and into the corresponding holes in the front

edge of the extension table. Install M8 x 40 countersunk socket head bolts through the rear rail and into the

corresponding holes in the rear edge of the extension table. See Fig. 5. Place an M8 washer and an M8 lock

nut on each bolt and hand tighten.

page 3

Fig. 4

Fig. 5