SawStop T-Glide Fence System - Manual (Page 4)

2. Installing the Rear Rail: You install the rear rail like you installed the front rail, except that you will probably
want to leave the rear rail a little loose until you get the extension table installed. The rear rail is attached to
the main table by two M8 x 25 countersunk socket head bolts. Position the rear rail along the back of the table
with the cut-outs at the top of the rail centered on the miter gauge slots in the table. Thread the bolts into the
tapped holes and tighten using the 5 mm hex driver. See Fig. 2.
Mount the rear rail to each extension wing using an M8 x 35 countersunk socket head bolt, an M8 washer, an
M8 lock washer and an M8 hex nut. If necessary, push down or pull up on the wings before tightening the nuts
to ensure the wings are parallel to the table. As mentioned above, it is usually easier to leave the bolts in the
rear rail slightly loose until the extension table is installed as it may be difficult to position the extension table
between the rails if both rails are tightened down.
3. Installing the Extension Table: Once the rails are in place you can mount the extension table to the rails. (If
you did not purchase an extension table, skip to step 4.) Begin by installing the adjustable foot in the bottom
of each support leg. The extension table for the 36” rails includes one support leg and the extension table for
the 52” rails includes two support legs. First, thread an M8 hex nut onto the threaded shaft of the foot as close
to the rubber base as possible. Next, thread the foot into the bottom of the support leg as far as possible. See
Fig. 3.
page 2
Fig. 2
Fig. 3
Use longer bolts
to mount rail to
extension table.