SawStop 1.75HP - Manual (Page 19)

SawStop 10” Professional Cabinet Saw 17
Standing Up Your Saw
3. With the help of another person, carefully roll the saw
off the pallet and onto the top piece of Styrofoam, as
shown in Fig. 3. You can use the cast iron table and
the elevation control shaft as lifting points to help
you roll the saw. Wear safety gloves and be careful
to use proper lifting technique to avoid injury.
4. With the help of another person,
carefully tip the saw to the
upright position by lifting under
the rear edge of the cast iron
table (see Fig. 4). Lift the saw
slowly so that it slides off the
Styrofoam and onto the fl oor
without damaging the cabinet.
Fig. 4
If you have a Professional Cabinet Saw Mobile Base ...
install it now while the saw is on its side. Refer to the manual that comes with your Professional Cabinet Saw
Mobile Base for instructions. Once the mobile base is installed, continue with step 4 to stand up your saw.
use the table and the
elevation control shaft
as lifting points to help
roll the saw
lift under the rear
edge of the table
Fig. 3