SawStop Premium Fence Assembly - Manual (Page 9)

4
3
6
13. Locate the main tube and remove seven M8x1.0x16 hex head bolts, seven M8x23x2 washers, and seven
M8 lock washers from the fence assembly hardware pack. Position the main tube on the horizontal portion
of the front rail with the rulers facing up and the 12 inch ruler on the left. The powder coated surfaces of the
main tube and rail can be slick, so be careful that the main tube does not fall off the rail. Align the holes in the
rail with the holes in the bottom of the main tube. Place an M8x23x2 washer and an M8 lock washer on each
M8x1.0x16 hex head bolt and insert the bolts through the rail and into the threaded holes in the bottom of the
main tube (see Fig. 13). Hand tighten the bolts; do not fully tighten them.
14. Locate the fence and the red fence handle. Thread
the handle into the cam lock on the front of the fence
(see Fig. 14).
Fig. 13
Fig. 14
Installing Your Fence Assembly
thread the handle into
the cam lock
Sa
wS
to
p
SawStop Premium Fence Assembly 7