SawStop Premium Fence Assembly - Manual (Page 8)

10. The extension table mounts to the rails
with bolts that pass through holes in
the rails and extension table. Take four
M8x1.25x25 flat head socket bolts and
insert one bolt into each of the remaining
holes in the front and rear rails. Place an
M8x23x2 washer and an M8 lock washer
on the back of each bolt and then thread
an M8x1.25 hex nut on each bolt (see
Fig. 10). Hand tighten the nuts; do not fully
tighten them.
Fig. 10
11. Make sure the extension table is flush against the right extension wing and there is no gap between them.
Then, use a straight-edge to level the front edge of the extension table to the cast iron table top (see Fig. 11).
You may have to pull up or push down on the outer edge of the extension table to level it. Once the front edge
of the extension table is level, use a 5 mm hex key and a 13 mm wrench to fully tighten the nuts on the bolts
that mount the extension table to the front rail. Repeat this process to level the rear edge of the extension table
to the cast iron table top.
Fig. 12a
Installing Your Fence Assembly
12. Place the straight-edge lengthwise across the middle of the extension wing and the extension table (see
Fig. 12a). Use a 5 mm hex key to turn the adjustment bolt clockwise or counter-clockwise until the middle of
the extension table is level with the extension wing (see Fig. 12b).
straight-edge
Fig. 12b
12
13 14
15
12
13
14
15
Fig. 11
level the front edge of the
extension table and tighten
the nuts on these bolts
straight-edge
adjustment
bolt
6 SawStop Premium Fence Assembly