Installing your fence assembly – SawStop Premium Fence Assembly User Manual

Page 4

1. Before you begin installing the Premium Fence Assembly, locate the front rail, the

rear rail, and the fence assembly hardware pack (see Fig. 1). All of the hardware

needed to install the fence system is located on the fence assembly hardware

pack. In order to easily identify the hardware used in each of the following steps,

the different pieces of hardware are numbered on the hardware pack and in the

figures. If you are missing the fence assembly hardware pack or any of the other

fence system components shown on page 1, call the SawStop Service Department

at 503-582-9934.

You will also need the following tools to complete the fence assembly installation:

• a 3 mm hex key

• a 5 mm hex key

• a 13 mm wrench

• a straight-edge

Fig. 1

2. Take the front rail (the larger of the two rails) and align it to the front edge of your saw by centering the notches

in the rail with the two miter slots in the table and aligning the two holes between the notches with the two

corresponding holes in the front edge of the table. Aligning the two holes between the notches aligns all the

other holes used in mounting the front rail to your saw; different holes are used for different saws. When

the holes are aligned, mount the front rail to the saw by taking four M8x1.25x16 flat head socket bolts and

threading one into each of the four threaded holes in the front edge of the main table (see Fig. 2). Tighten the

four bolts using a 5 mm hex key.

Fig. 2

notches

Note: Your saw must be fully assembled before installing the fence system.

miter slots

front rail

2 SawStop Premium Fence Assembly

Installing Your Fence Assembly

Fence Assembly Hardware Pack

Flat Head Socket Bolts,

M8x1.25x25 (8)

Flat Head Socket Bolts,

M8x1.25x16 (8)

Washers,

M8x23x2 (15 + 1 extra) 3

Lock Washers,

M8 (15 + 1 extra) 4

Hex Nuts,

M8x1.25 (8) 5

Hex Head Bolts,

M8x1.0x16 (7)