SawStop Fence Assembly - Manual (Page 8)

! WARNING
For your own safety, read the instruction manual before operating this saw.
1. Wear eye protection. Use the blade guard and spreader for every operation for which it can be used, including all through sawing. 3. Keep hands out of the line of the saw blade. 4. Use a push-stick when required. 5. Know how to reduce the risk of kickback. 6. Do not perform any operation freehand. 7. Never reach around or over the saw blade. 8. Never try to test fire the brake system. 9. Never adjust the position of the brake cartridge while the blade is spinning. 10. Do not try to disable the brake system. 11. Unplug the saw before changing the blade, changing the brake cartridge or servicing. 12. Do not connect the motor directly to a power supply. 13. Use the bypass switch only when necessary. 14. Do not expose to rain or use in damp locations. 15. Do not put your hands inside or underneath the cabinet while the blade is spinning.
WARNING
Moving belts and par ts
can pinch, cut or cr ush.
Do not oper ate with
belt guard op en.
Made in Taiwan SawStop, LLC www.sawstop.com TCP
10¨ Contractor Saw
SawStop ®
Model No. CNS 175 Serial No. C074012345
Electrical / Electricidad / Électricité
115/230 Volts, 60 Hz 15/7.5 Amps 1 Phase
1.75 HP 3500 RPM
® c US 175370
engage
fence clamp
on rear rail
6 SawStop Contractor Fence Assembly
S
a
w
S
to
p
13. Position the fence on the table and to the right of the blade. Make sure the clamp at the rear of the fence
engages the rear rail (see Fig. 13), and that the front of the fence engages the front rail.
Fig. 13
14. To determine the final placement of the front rail, raise the saw blade and position the fence so that the left side
of the fence rests against the right side of the saw blade (see Fig. 14).
Fig. 14
Installing Your Fence Assembly