SawStop Fence Assembly - Manual (Page 7)

thread the
handle into
the cam lock
SawStop Contractor Fence Assembly 5
Sa
wS
to
p
Installing Your Fence Assembly
Fig. 11
20
17
18
11. The two small storage hooks also mount to the material support
shelf, and can be used to store the miter gauge when not in use.
Use two M8 x 20 carriage bolts, two M8 lock washers, and two
M8 hex nuts to mount the hooks to the left side of the material
support shelf (see Fig. 11). Fully tighten the nuts using a 13 mm
wrench.
12. Locate the fence and red fence handle. Thread the handle into the
cam lock on the front of the fence (see Fig. 12).
Fig. 12
10. The two large storage hooks mount to the material support shelf,
and can be used to store the fence when not in use. Use two M8
x 20 carriage bolts, two M8 lock washers, and two M8 hex nuts to
mount the hooks to the right side of the material support shelf (see
Fig. 10). Fully tighten the nuts using a 13 mm wrench.
17
18
20
Fig. 10