SawStop Fence Assembly - Manual (Page 5)

4. Place an M8 lock washer and thread an M8 hex nut on the back of
each of the eight square head screws (see Fig. 4), but do not fully
tighten the nuts at this time. Position the front rail so that the left end
of the rail extends about 3 ⁄
4
inch past the edge of the left extension
wing.
Fig. 4
18
17
SawStop Contractor Fence Assembly 3
Fig. 5
19
19
19
17
17
17
18
Fig. 6
19 17
19
19
17
18
17
5. Mount the left rear rail (the shorter rail) to the rear of
the table and to the left extension wing using three
M8 x 16 hex screws, three M8 lock washers, and one
M8 hex nut (see Fig. 5). Insert one hex screw into the
hole in the extension wing and then use a lock washer
and hex nut to hold the screw in place, as shown. The
other two hex screws thread into corresponding holes
in the cast iron table. Place a lock washer on each
screw before threading them into the holes. Hand
tighten the hex screws; do not fully tighten them.
Installing Your Fence Assembly
6. Repeat the same procedure to mount the right
rear rail (the longer rail) to the rear of the table
and to the right extension wing. Again use three
M8 x 16 hex screws, three M8 lock washers,
and one M8 hex nut (see Fig. 6). Hand tighten
the hex screws; do not fully tighten them. The
right rear rail should extend beyond the right
extension wing.