Installing your mobile base – SawStop Mobile Base User Manual

Page 7

Installing Your Mobile Base

15 16

Fig. 11

Fig. 12

Fig. 13

SawStop Contractor Mobile Base 6

11. Locate the release lever and the M8 x 30 hex screw and

fully thread the screw into the threaded hole in the release

lever (see Fig. 11).

release

lever

12. The release lever attaches to the foot pedal arm of

the wheel support. The release lever includes a non-

threaded hole, roughly in the middle of the lever, that

aligns with a threaded hole in the foot pedal arm, as

shown in Fig. 12. Place the M10.5 x 14.5 wave washer

over the shoulder of the M8 x 17.7 shoulder socket

screw. Then insert the shoulder socket screw through

the non-threaded hole in the release lever so that the

hole fits over the screw’s shoulder, and then thread the

screw into the hole on the foot pedal arm. Fully tighten

the screw with a 5 mm hex key.

release lever

foot

pedal

arm

13. Locate the extension spring and the release lever locking screw. Note

that the screw has two shoulders, one with a larger diameter next to the

head, and one with a smaller diameter next to the threads. Slide one end

of the extension spring over the larger shoulder (see Fig. 13).

larger shoulder

threaded hole

non-threaded

hole