SawStop Mobile Base - Manual (Page 6)

Installing Your Mobile Base
11
10
12
3 4
13
Fig. 8
Fig. 9
Fig. 10
5 SawStop Contractor Mobile Base
8. Mount the two casters to the outer corners of the caster
support by inserting the threaded shaft on the casters through
the corresponding holes in the support and holding the casters
in place with two M10.5 x 25 washers, two M10.5 x 17 lock
washers and two caster nuts, as shown in Fig. 8. Fully tighten
the caster nuts with a 14 mm wrench.
9. Next, install the linkage bar between the wheel support and
the caster support. To do this, remove the M6 nylon hex
nut and the M6 washer from the axle for the wheel closest
to the foot pad (this is the nut that was not tightened in
step 3), but do not remove the axle or wheel. Locate the
linkage bar and note that it has a non-threaded hole at
one end and a plastic washer glued near the middle of
the linkage bar. Position the linkage bar so that the plastic
washer faces toward the inside of the stand, and slide
the non-threaded hole at the end of the linkage bar over
the exposed shoulder on the axle, as shown in Fig. 9.
Reinstall the M6 washer and the M6 nylon hex nut on the
axle and fully tighten the nut with a 10 mm wrench and a
5 mm hex key.
10. Connect the other end of the linkage bar to the
connecting lever on the caster support by inserting the
M8 x 15.7 shoulder socket screw through the hole in the
connecting lever so that the hole fits over the shoulder
on the screw, and then threading the screw into the
threaded hole in the linkage bar, as shown in Fig. 10.
Fully tighten the shoulder socket screw with a 5 mm hex
key.
linkage
bar
linkage bar
connecting
lever
plastic washer axle
non-threaded
hole
3 inch
caster