Alpine DVA-5205P - Manual (Page 8)

8
DVD / AUDIO
When using remote control
Replacing the batteries
Opening the battery cover
Push on the cover and slide it as
indicated by the arrows then the cover will
be removed.
Closing the cover
Push the cover in the arrow direction until
a click is heard.
Note: Use two AA size batteries.
When using remote control
• Mode Switch
To operate the DVD Player, make sure
the mode switch is on “DVD”. DVD
operations are shown as the blue
characters on the remote control unit.
Switching to “AUDIO” mode, makes it
possible to operate Alpine audio
products as well. Audio operations are
shown as the white characters on the
remote control unit.
• Point the remote control at the remote
sensor within about 2 meter.
• It may not be possible to operate the
remote control unit if the remote control
sensor is exposed to direct sunlight.
• The remote control is a small, light
weight precision device. To avoid
damage, short battery life, operational
errors and poor button response,
observe the following.
- Do not apply any shock.
- Do not put in a trouser pocket.
- Keep away from food, moisture and
dirt.
- Do not place in direct sunshine.
DO NOT OPERATE ANY FUNCTION THAT TAKES YOUR ATTENTION AWAY
FROM SAFELY DRIVING YOUR VEHICLE. Any function that requires your
prolonged attention should only be performed after coming to a complete stop.
Always stop the vehicle in a safe location before performing these functions.
Failure to do so may result in an accident.
Warning
Replacing the battery
Remove the old batteries. Insert new
ones matching the (+) and (–) polarities
as shown in the diagram inside the
remote control.
-
+
+
-