Rivera Primo Direct Drive Belt Drive - Manual (Page 7)

7
Drill 2ea. 1/4 holes in cross hairs. Using a 82de counter sink or a 31/64 drill bit,
Sink the top of 1/4 holes so that the flat head cap bolts are flush.
Install center adjuster screw.
(SEE FIGURE 19)
Adjust clutch by backing off cable
first all the way, then turn in adjuster
screw until contacting push rod. Back
off 1/4 turn, install jam nut and tighten.
(Hold lever against grip to feel when
adj.screw contacts pushrod, the lever
will start to move).
(SEE FIGURES 20 & 21)
FIGURE 19
FIGURE 20
FIGURE 21
6