Rivera Primo Direct Drive Belt Drive - Manual (Page 4)

Install front and rear pulley with belt.
Make sure that the battery c a b l e
and solenoid wire are exiting inside
the belt between front & rear pulleys.
Align front pulley bolt holes with front
pulley insert bolt holes. Seat front and
rear pulleys fully on shafts.
(SEE FIGURE 10)
Use one 5/16-18 x 1 1/4” bolt to at-
tach
front pulley to insert. Rotate pulleys
slightly to align the front pulley holes
with the insert holes. Now install all
five 5/16-18 x 1 1/4” bolt. Use blue
thread locker on each bolt of front
pulley and tighten to correct torque
specs.
FIGURE 8
FIGURE 10
FIGURE 11
Install ring gear cover with (4) 8- 32 X
1/2” bolts supplied. Use one drop of
blue thread locker per bolt.
(SEE FIGURE 8)
At this point you may install the
included degree pointer onto ring
gear cover with two 8-32 x 1/2” inch
bolts and washers and one drop of
blue thread locker per bolt. (SEE
FIGURE 9)
FIGURE 9
4