Rivera Primo Brute III - Manual

I
t is common knowledge that a belt drive primary provides advantages & service that a standard chain drive
primary cannot. For dependable, high-performance, long lasting service nothing beats a modern Primo®pri-
mary Belt Drive! A long standing tradition of ”Quality & Performance” has made Primo® Belt Drive systems
the most popular in the world! The wet clutch nightmare is over, no more leaky primary, no more draining the
primary for inspection or maintenance. Carefully read & follow these instructions for a quick, convenient instal-
lation. If you have any questions please call (562) 907-2600.
IMPORTANT SAFETY NOTICE....
When performing any motorcycle work such as installing a belt drive, secure the motorcycle in an upright posi-
tion with convenient access to the primary drive. If you are working with the motorcycle on a lift make sure it is
securely fastened to prevent it from falling.
Remove the battery prior to starting the installation.
Drain the primary case, remove both the inner & outer pri-
mary covers, & all OEM chain drive components from the
primary chaincase. Thoroughly clean the inner & outer
primary covers to
remove all traces
of
primary fluid.
Pictured is a 1995
H a r l e y - D a v i d s o n
®
Dyna-Glide primary.
Remove the factory
bearing race from the
transmission main-
shaft using the Jims
tool part # 34902-84.
1 2
Install the sealed bearing (1018-0021) Strip the primary
Install Primo’s one-piece, sealed bearing included in the kit.
2108-0001 Rev. 9/2014
8mm - 1-3/4” Wide
FITS:
1986-2000
FXR, FLT & FLH
1986-89 Softails
INSTALLATION INSTRUCTIONS FOR PRIMO’s
BRUTE III TM BELT DRIVE
www.riveraprimoinc.com
1
HOME OF PRIMO®BELT DRIVES
QUALITY & PERFORMANCE SINCE 1973