Rivera Primo Direct Drive Belt Drive - Manual (Page 5)

Put a few drops of blue thread locker
in motor sprocket shaft nut. Install nut
on sprocket shaft and torque to 150-165
ft lbs. (SEE FIGURE 11)
Put two drops of blue thread locker on
left hand thread transmission main
shaft
nut. Install nut on transmission main
shaft and torque 80 to 90 ft lbs.
(SEE FIGURE 12)
Put small amount of anti-seize on motor
plate starter shaft bushing prior to in-
stalling starter. Using two supplied 5/16-
18 x 1” flathead countersunk bolts with
1 drop of blue thread locker, install spe-
cial Direct Drive
™
starter between front
& rear pulley with solenoid pointed to-
ward rear pulley. (SEE FIGURE 13)
Routing wire between solenoid and starter
body, cut to
length and attach 14 gauge so-
lenoid wire to small blade type terminal on
solenoid. Pull any slack wire to the rear of
the motor plate. (SEE FIGURE 13)
Attach starter relay cable to lower large
stud on solenoid. Pull any slack cable to
the rear of the motor plate. (SEE FIGURE
14)
FIGURE 14
FIGURE 13
FIGURE 12
5