Rivera Primo Brute IV Extreme Touring 2007 - Manual

NOTE: Read the instructions carefully before proceeding with the actual installation.
NOTE: To avoid accidental start up of vehicle during the installation, remove both battery
cables & the battery. Securely block motorcycle in an upright position. Different models will
require the removal of shifting levers, foot pegs, etc. Remove whatever is necessary to
accomplish the installation per your OE service manual.
(On all 2007 & some 2008 models, you must replace the alternator rotor with part # 30041-08)
Using your OE manual, strip the motorcycle down to
what is shown in Figure 1. Remove the bearing race
from the transmission mainshaft using JIM’S part #
34902-84. Remove alternator rotor and check sprocket
shaft oil seal. The steel back on this seal should face
away from the engine when using a primary belt drive
which will keep oil from leaking out of the motor. (Use
seal HD part # 12068).
NOTE: Although the motorplate will come pre-assembled
and ready to install from the factory (See Figure 3), in
the event that it becomes necessary to disassemble it
we are including some of the steps needed to re-assem-
ble it.
Install the motorplate spacers (2 round spacers with hollow dow-
els on trans side, one starter spacer with engraved logo and 2
split hollow dowels on the starter side, and one alternator spac-
er) onto the hollow dowels already installed on the motorplate.
(see figure 4).
NOTE: The round spacers have a beveled edge on one end and
a crisp edge on the other end. The beveled end goes toward the
trans and the crisp edge goes up against the motorplate. (See
figure 5).
Install the dowels using the method as per figure 4.
Use a 5/16-18 x 3” bolt, 5/16” flat washer & 5/16-18 nut
to install all the hollow dowels except for the lower front
mp bolt hole which will require a 1/4-20 x 3” bolt, 1/4”
flat washer & 1/4-20 nut.
Figure 3
Figure 4
BRUTE IV EXTREME
TM
TOURING 2007 & 2008
INSTALLATION GUIDE
1 2 4 5 0 W H I T T I E R B L V D . , W H I T T I E R , C A 9 0 6 0 1
W W W . R I V E R A P R I M O I N C . C O M
On 2007 models and some 2008 models it will be
nessecary to replace the stator rotor with the later OE
part # 30041-08. (We stock this part). (See figure 2)
Figure 1
Figure 2
Figure 5