Rivera Primo Direct Drive Belt Drive User Manual
Page 2
2
Disconnect and remove battery from
oil tank.
Remove starter motor. (Removal of oil
tank may be necessary on some models
to remove starter motor).
Remove inner & outer primary case and
primary drive components.
Install transmission flange cover (with
Primo logo) first, using supplied 5/16-18 X
1” bolts. (SEE FIGURE 1)
Install relay with mounting flange
pointed toward front of bike, by drilling
two 1/4” holes in the battery tray of oil
tank using template on page 6.
Secure relay with 1/4-20 x 3/4” flat
socket head cap bolts and KEP nuts pro-
vided. (SEE FIGURE 2)
Attach positive battery cable to large
post in back of relay (left side of bike)
and 14 gauge wire to small post that is
marked ‘solenoid’. Take wire from OE
starter and attach to small post that
reads ‘solenoid’ or ‘S’.
FIGURE 1
FIGURE 2
FIGURE 3
Re-install oil tank. Attach positive
battery cable to large post on front
of relay. Route starter cable and
solenoid wire over top of transmission
toward motor.
Install rear motor plate to transmission
with 4 each 5/16-18 x 2 1/2” shcs bolts
provided. Leave bolts slightly loose at this
time. (SEE FIGURE 3)
Bottom of oil tank