Rugged Ridge All Terrain Fender Flare Kit, 87-95 Jeep Wrangler (YJ) - Manual (Page 2)

Rev. 11/11 Page 2 of 4 SB
YJ: 11632.10
CJ: 11633.10
CJ/YJ ALL TERRAIN FLARE KIT
Step 6. Install the hardware as shown in the image. First place a washer on
the M5 bolts. Place one bolt through each hole in the flare. Next
place a rubber spacer on the bolt on the back side of the flare. Some
of the spacers are different in thickness. Follow the instructions in
the next steps to determine placement of each spacer.
Step 7. Installing the front flares. First you will install the side marker in the
flare using two phillips head screws. Install a 7mm rubber spacer
on both marker light screws. Install one 7mm rubber spacer on the
front mounting screw. Install a 13mm spacer on the remaining
mounting screws. Mount the flare on the body placing a M5 nut on
each bolt. Finally tighten the side marker screws. Do not over
tighten the marker light screws or mounting nuts.
Step 9. Install the front flare extensions using the factory M5 bolts.
Step 8. Installing the rear flares. Install the rear fender flares using a 7mm
rubber spacer on each screw. Mount the flare on the body placing
a M5 nut on each bolt. Finally tighten the nuts. Do not over
tighten the mounting nuts.