beautypg.com

Rugged Ridge Cold Air Intake Kit, V8, 93-98 Jeep Grand Cherokee (ZJ) User Manual

Page 3

background image

© Copyright 2009, Omix-Ada

Omix-Ada Inc.

460 Horizon Dr. Suite 400

Suwanee, Georgia 30024

Page 3 of 3

8. Congratulations on the purchase and installation of another quality Rugged Ridge product.

6. Attach 3” Hose to Plenum before installing to throttle body using OE plenum nut. Do not tighten. Slide (2)

Hose Clamps onto hose but do not tighten. Slide Air Intake Tube into 3” Hose. Next, slide (1) Hose Clamp onto

the flange of the Air Filter before sliding it onto the end of the Air Intake Tube inside the Heat shield. Note:

This filter is polyester synthetic and never needs to be oiled. It can be cleaned with warm water and mild

detergent dish soap

7. Once Air Intake Assembly is properly positioned inside Heat Shield. Tighten bracket of Intake Tube onto

Rubber Mount. Tighten hose clamps to secure Intake Tube and Air Filter into place. Tighten plenum nut.

Attach Breather hose to Air Intake Tube. The small breather hose should be zip tied to power steering fluid line.