Rugged Ridge Cold Air Intake Kit, V8, 93-98 Jeep Grand Cherokee (ZJ) - Manual

17750.22
ZJ 93-98 Air Intake Kit - 5.2L, 5.9L
Contents:
1. Intake Tube (1)
2. Heat Shield (1)
3. Air Filter (1)
4. Rubber Hose (1)
5. Hose Clamp (3)
6. Rubber Isolator Mount (1)
7. M8 Washer (6)
8. M8 Nylock Nut (2)
9. M8x1.25x20mm Bolt (2)
10. M8x1.25 Nut (2)
11. M8 Lock Washer (2)
12. Plenum (1)
13. Plenum support (1)
14. 1/4-20x2.5” Stud (1)
15. Rubber Throttle Body Gasket (1)
16. Throttle Body Spacer (1)
17. Throttle Body Spacer Gasket (2)
18. Weather stripping (2)
19. Zip Tie (2)
20. Rubber Edge Trim (1)
Page 1 of 3
1. Remove original air intake system including air filter housing, air filter, breather hoses, inlet duct and
OE plenum. OE plenum nut will be used later to secure supplied Plenum to throttle body.
2. Prepare Heat Shield for installation by applying Weather Stripping to upper edges and install Rubber Mount.
Apply Rubber Edge Trim to cuttout in Heat Shield for the Intake Tube. Remove bolt from washer fluid reservoir
and reuse bolt to install Heat Shield. Use M8 Hardware to secure Heat Shield to original air box bolt holes.