Rugged Ridge XHD Aluminum Front Bumper, Non-Winch Mount - Manual (Page 8)

Copyright © 2013 Omix-Ada ® , Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
Page 8/8
Stubby Ends (11541.10/11542.23)
NOTICE: Bumper should be installed on vehicle prior to stubby end installation
Contents:
1. Stubby End (2)
2. M12 Hex Bolt (6)
3. M12 Washer (12) 4. M12 Lock Nut (6)
ALUMINUM XHD & ALL TERRAIN BUMPER SERIES
1. Remove plastic plugs from sides of center section if
present.
2. Attach stubby ends to center section using M12
hardware. Note: Bolt heads should be inside stubby
ends and lock nuts inside center section.