Rugged Ridge XHD Aluminum Front Bumper, Non-Winch Mount - Manual (Page 5)

Copyright © 2013 Omix-Ada ® , Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
ALUMINUM XHD & ALL TERRAIN BUMPER SERIES
Mini Stinger (11542.13)
Contents:
1. Mini Stinger (1)
2. M8 Bolt (8) 3. M8 Washer (16)
4. M8 Lock Nuts (8)
1. Remove Aluminum XHD bumper or All Terrain
bumper if previously installed. Twist plug at rear of
fog light to disconnect wiring. Slide the bumper off
frame.
2. Position mini stinger on top of center section.
Align mounting holes with slotted cutouts on the
XHD Aluminum Bumper, or with 4 holes on All
Terrain Steel Bumper (remove pre-installed rubber
plugs from holes on All Terrain steel bumper). Install
using M6 hardware with the washers on bottom.
3. Fasten d-ring portion of mini stinger and
center section to frame rails using M12 hardware
and nut plates. Tighten evenly. Rubber gaskets
included with Aluminum XHD mount between
d-ring section of mini stinger and center section.
Page 5/8