Rugged Ridge XHD Winch Mount Front Bumper, 76-06 Jeep CJ & Wrangler Models - Manual (Page 4)

8. Installation of the Bumper is now complete! You may now install any hoops, auxilary lighting, etc.
Note: When used for vehicle recovery, only the D-Rings are to be used. Hoops are not to be used
for towing or vehicle recovery.
Page 4 of 4
Congratulations on the purchase and installation of a quality Rugged Ridge product! Ask your retailer
about the following additional accessories to the XHD Modular HD Bumper:
11540.17 - Optional Stainless D-Rings
11540.48 - Optional RRC Hoop
11540.13 - Optional Stinger
11540.14 - Optional Hoop - Black
11540.16 - Optional Hoop - Stainless
11540.42 - Optional Bumper Ends
7. Inspect all mounting bolts to make sure they have been tightened. Double check D-rings to make
sure they are secured to bumper cover and sub-frame. Reinstall side cover plates to bumper cover.
Run winch power leads and make sure they DO NOT rub on XHD bumper cover or sub-frame.
Please find warranty card supplied with product for more information. Warranty card should be filled out and returned to address listed below.
LIMITED WARRANTY
Applies to Rugged Ridge Products by Omix-Ada Inc.
Omix-Ada Inc.
460 Horizon Dr. Suite 400
Suwanee, Georgia 30024