beautypg.com

Rugged Ridge Tire Carrier, XHD Rear Bumper, 07-14 Jeep Wrangler (JK) User Manual

Page 8

background image

Page 8 of 9

24. Pull the carpeting away from the tailgate seal. Route the wiring for the third brake light wiring along

the tailgate seal. You do not have to tuck it behind the seal, as it will be concealed by the carpet.

Route the wiring under the lower right hand corner of the tailgate seal.

25. Wrap the wiring with the provided Wire Loom (#30) beginning inside the vehicle. Pass the wrapped

wire between the body and the tailgate seal. Close the tailgate and continue to route the wiring to the

tire carrier. Route the wiring along the tire carrier as shown. Secure wiring to Tire Carrier with

Wire Ties (#29).

25. Reinstall the harness removed in Step 17. Install the third brake light assembly into the new light

bracket that was provided with your new tire carrier. Install the 4 provided phillips head screws

(#23 ) and tighten. Be careful not to over-tighten these screws.