beautypg.com

Rugged Ridge Tire Carrier, XHD Rear Bumper, 07-14 Jeep Wrangler (JK) User Manual

Page 2

background image

Page 2 of 9

2. Place Pivot Mount (#2) on the right side of the bumper. Install using M12 Hex Bolts (#7) in the top
holes, and place the D-Rings and its corresponding bolts in place on the rear holes. Leave all bolts
loose. Note - (2) bolts that are closest to the tailgate do not get washers. All other bolts do.

3. Place Latch Mount (#3) on the left side of the bumper. Install using M12 Hex Bolts (#7) in the top
holes, and place the D-Rings and its corresponding bolts in place on the rear holes. Leave all bolts
loose. Note - (1) bolt that is closest to the tailgate does not get a washer. All other bolts do.

4. Pre-assemble Spare Tire Mount. Spare Mount Plate (#13) and Spare Adjuster Plate (#15) nest inside
one another. Fasten together with (4) M12 Hex Bolts (#7), (8) M12 Washers (#6), and (4) M12 Lock
Nuts (#14) as shown. Leave fasteners loose.