Martin Universal Design U-DS40 SMART TABLE - Manual (Page 3)

03/2009- RPI
FIG 3
Pg. 3
FIG 5
U-DS40 SMART TABLE • Assembly Instructions
STEP 3] Attach Adjustable Rubber Feet
Attach the [4] adjustable rubber feet (part E) to Legs
(part C) by threading the rubber feet clockwise into the
bottom holes of the legs. See Fig 3 images.
NOTE: To adjust the level of the base once assembled,
unscrew or tighten each rubber foot until table is level.
C
E
FIG 4
STEP 4] Base Assembly
Take the [2] legs (part C) that have the rubber feet
attached and the [1] Base cross support (part D).
Attach the base support (part D) to each leg using [2
each] 6x40mm Allen bolts (part L) to each leg. Line up
holes in the legs to the ends of the base support. Insert
bolt through outer side of legs and into holes on end
of base Support.
Tighten bolts with Allen Wrench.
See FIG 4
D C
C
E
C
L
G
STEP 5] Attach Collars to Base Legs
Zoom of Bolt attachment
Attach the [2 each] Collars (part G) to the top ends of
the legs as shown in the picture in FIG 5.
Make sure the knob is positioned on the outer side
of the legs.
NOTE: Loosen the knob on the collar (part G) prior
to sliding the collar down over the legs (part C).
L
C