Minka Group F528-L-BS/CH - Manual (Page 23)

12
TROUBLESHOOTING
SYMPTOM
Fans/Light Turn On
and Off Unexpectedly
SOLUTION
This is caused by
interference, change the
code frequency from the
transmitter, and follow the
instructions from Section 5
again to operate your
transmitter and fan.
SYMPTOM
Fan Sounds Noisy
SOLUTION
Allow a 24-hour "break in" period.
Most noises associated with a new
fan will go away during this time.
Make sure the screws that attach the
fan blade holder to the motor hub is
tight.
Make sure outlet box is secured to
building structure, if necessary use
the wood screws provided to further
secure outlet box to joist.
Make sure hanger bracket is secure to
the outlet box, screws are tight.
SYMPTOM
Fan will not start
SOLUTION
Check to make sure the wall switch is
turned on.
Check circuit fuses or breakers.
Caution! Make sure the power is turned
off before performing the following steps.
Remove canopy and check wire
connections.
Check wall control transmitter connections
(if applicable).
Note: Fan must be installed at a maximum
distance of 40 feet from the transmitting
unit for proper signal transmission
between the transmitting unit and the
fan's receiving unit.
SYMPTOM
Fan Wobble
SOLUTION
NOTE: All blade sets are grouped by weight.
Because wood and plastic blades vary in
density, the fan may wobble even though
blades are matched.
Make sure outlet box is secured to building
structure, if necessary use the wood screws
provided to further secure outlet box to joist.
Make sure hanger bracket is secure to the
outlet box, screws are tight.
Use the balancing kit provided if the wobble is
excessive (follow instructions included with
balancing kit).