Minka Group F528-L-BS/CH - Manual (Page 20)

10
OPERATING THE REMOTE CONTROL/WALL CONTROL
Restore Power to Ceiling Fan.
A. Buttons:
These buttons are used to set the fan speeds as
follows;
= Low Speed
= Medium Speed
= High Speed
B. Button:
This button turns the fan off.
C. Button:
These buttons turn the light ON or OFF and also
control the brightness settings of the light. The
following instructions apply to ceiling fans that
feature a DOWN light ( button) only or ceiling
fans that feature an UP light ( button) and a
DOWN light ( button) that are controlled
independent of each other:
Press and release the button for the desired light
to turn the light ON or OFF. Press and hold the
button to set the desired light brightness. The light
will cycle between bright and dim settings as long
as the button is pressed. The light key has an
automatic auto-resume feature that allows the
light to remain at the same brightness as the last
time it was turned off.
D. OFF-ON Slide Button (Wall Control Fans Only)
This button turns the power Off and On to the Fan
and Light(s).
E. Button: (Full Function Remote Control Units
Only)
This button is used to change the direction of the
rotation of the blades; forward for warm weather
or reverse for warm weather.
NOTE: If your Remote Control or Wall Control does
not have a " " button, Please look for a slide
reverse switch on the motor housing.
Speed settings for warm or cold weather depend
on factors such as room size, ceiling height and
number of fans.
NOTE: Wait for fan to stop before changing the
setting of the slide switch.
Remote Control only: Install a A23 12 volt battery (included). To prevent damage to transmitter remove the battery if not used for long periods of time.