NaceCare Solutions TTV678 - Manual (Page 8)

233890 05/11 (A03) 8
Machine Set Up
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF
BEFORE MAKING ANY ADJUSTMENTS
! !
Fitting the side pod skirts
To fit the side pod skirts, first remove the steel retaining strip already fitted to the pod (fig 6a).
Align the steel retaining strip within the locating grooves of the rubber skirt and refit using existing screws (fig 6b)
Periodically the side skirts should be examined and checked for wear and damage. Replace as shown above.
Fitting the floor-tool
Fig.6a Fig.6b
Lower the floor-tool arm by moving the release lever to the upper position (fig. 7)
Push floor-tool onto the holder and secure with the easy-fit securing pin (fig 8)
Push waste collection pipe onto the floor-tool; ensure a tight fit (fig 9)
Note: Raise floor-tool again before driving to the cleaning area (fig.9a)
Fig.7
!
Fig.8 Fig.9a
Fig.9