NaceCare Solutions TTV678 - Manual (Page 12)

233890 05/11 (A03) 12
Machine Set Up
Lowering the brush deck
Lowering the floor tool
Fig.20 Fig.21 Fig.22
Fig.23
After preparing the floor (see previous section), we are now ready to set the controls to suit the cleaning conditions.
Before any settings can be applied, ensure the brush deck is lowered.
While depressing left-hand foot pedal (see fig.20), press down the release lever (see fig.21) and gently release
the foot pedal to lower the brush deck (see fig.22).
Note: If the brush width has not been set, see ‘Setting the width adjustment’ on page 8 before proceeding.
Lower the floor-tool by moving the release lever to the upper position (fig. 23)
NOTE
: The machine will not reverse while the floor-tool is in the lowered position - ‘Causes the battery indicator to flash’.