NaceCare Solutions ST765 - Manual (Page 6)

Note: When the flashing 0 appears on the battery indicator, the brushes will
automatically shut down. The machine then has enough of a charge left to
return it to the recharging area.
SQUEEGEE
The squeegee comes un-attached in the box for packing reasons. The
squeegee must be installed on the machine as shown.
The rear rubber, during operation, must be slightly and uniformly bent back
about 5 mm. along its entire length. It may be necessary, to increase
curvature of the rubber in its central section, to slope the squeegee body
backwards. This is done by rotating adjustment unit (2, fig. 31 counter-
clockwise. To increase curvature on the outside sections of the rubber just
rotate adjustment unit (2, fig. 3) clockwise.
ADJUSTING THE HEIGHT OF THE SOUEEGEE SUPPORT The
squeegee must be adjusted in height depending on rubber wear.
Do this using knob (1):
-
Turning them clockwise raises the squeegee:
- Turning them counter-clockwise lowers the squeegee. The right and
left wheels must be adjusted at the same height, otherwise the squeegee
cannot work parallel to the floor.
INSTALLING THE BRUSHES
-
Use lever (1) to lift the base (lever downwards)
- Turn key (2) to OFF and remove it from the control panel
(installing the brushes with power on may cause injury)