beautypg.com

NaceCare Solutions ST765 User Manual

Page 14

background image






CLEANING THE SQUEEGEE
The squeegee must be in perfect working condition to achieve a good
drying process. It must be clean and its rubbers must be in good condition.
Proceed as follows to clean the squeegee:

• Remove it from the machine by pulling pin (1) out from column (2).

Clean the interior with a jet of water.

• Loosen knobs (3), remove block (4) and check that there is no dirt inside.

• Check the condition of the rubbers and reverse or replace them as

necessary.

• Replace everything on the machine.




REPLACING THE REAR SQUEEGEE RUBBER
The drying edge can be changed if the squeegee rubber is worn and does
not dry properly:

• Use a hammer to push and rotate lock plates (1) in the directions

indicated by the arrow.

• Pull out the rubber-pressing blade and the rubber.

• Turn the rubber over or replace it if necessary.

• Check the height of the squeegee, Adjust using knobs (2) as necessary.

• Replace everything by carrying out these procedures in reverse order.





REMOVING THE BRUSHES
- Push lever (1) down to raise the base
- Turn key (2) to OFF and remove it from the control panel (removing the

brushes with power on may cause Injury to the hands).











- Rotate the brush, with the base raised, until it exits from the brush-

bearing plate as illustrated. The picture shows the direction of rotation for
releasing the right brush. Rotate in the opposite direction for the left
brush.







This manual is related to the following products: