DiGiCo SD11 - Manual (Page 20)

SD11 - Getting Started
1-15
1.9 Channel Processing
1.9.1 EQ ..........................................................................................
The EQ section comprises four user-configurable parametric filters and a pair of swept High-pass and Low-pass filters.
The EQ is accessed by touching the on screen display to Assign the channel (the colour changes to yellow) and then using
the controls on the right hand side of the screen.
When a control is adjusted the expanded view seen below appears in the input screen but this view can be seen at any time by
touching the EQ response graph on the screen.
Note - If the expanded view does not appear when a control is adjusted open the Options panel and set the
Auto Expand EQ option to Yes
Touching the normal EQ response graph will show an expanded view in a separate panel.
EQ Presets Copy EQ Settings
EQ Type
HPF/LPF
4 Bands
Dynamic EQ
The type of filter used by the top and bottom bands can be changed by successive presses of the Curve button for that band.
Up to 4 (6 for SD11i) Channels can have their EQ modules switched into Dynamic EQ mode by touching the red "Delta" symbol on
any EQ band.
On any channel (Input or Output), open the EQ Module, and expand the dynamic controls. You can then switch on any (or all) or
the dynamic controls for that EQ Module.
An warning message will appear on screen if an attempt is made to use Dynamic EQ on more than 4 channels (6 for SD11i).
See the SD Series Software Reference manual for more information on Dynamic EQ