Foreword, Rbc manual – Beijer Electronics RBC EN User Manual

Page 2

Foreword

RBC Manual

Foreword

The Remote Backlight Controller (RBC) module is a part of the MTe monitor
series and of the EPC C2D Nautic series. The main purpose of this module is to
enable remote access to some of the monitor parameters or features, especially the
backlight.
Supported features are dependant on the device with the built-in RBC module.
Dimming can be carried out using the buttons on the front, or remotely by
interpreting SCOM commands received from the RS232, RS485 or USB
interface. The internal ﬁrmware manages all software tasks including the SCOM
command handling.
This manual describes the features, the conﬁguration and the usage of the RBC
module.

Order no: MAEN986C

The information in this document is subject to change without notice and is provided as available at the

time of printing. Beijer Electronics AB , including all its group companies, reserves the right to change any

information without updating this publication. Beijer Electronics AB assumes no responsibility for any

errors that may appear in this document.

All examples in this document are only intended to improve understanding of the functionality and

handling of the software. Beijer Electronics AB cannot assume any liability if these examples are used in real

applications.

In view of the wide range of applications for this software, users must acquire sufﬁcient knowledge themselves

in order to ensure that it is correctly used in their speciﬁc application. Persons responsible for the application

and the equipment must themselves ensure that each application is in compliance with all relevant

requirements, standards, and legislation in respect to conﬁguration and safety. Beijer Electronics AB will

accept no liability for any damage incurred during the installation or use of this software. Beijer Electronics

AB prohibits all modiﬁcation, changes, or conversion of the software.

Beijer Electronics, MAEN986C