Beijer Electronics RBC EN - Manual (Page 12)

Firmware
2.1.4 Startup Brightness Mode
The Startup Brightness Mode specifies backlight brightness after power on or
reset, in one of the following ways:
• darkest (0)
• brightest (255)
• default brightness
• last brightness before power off
By changing the Default Brightness, it is possible to start the device with any
brightness in the allowed range of 0 to 255.
Related information
Default Brightness
2.1.5 Keypress Mode
The Keypress Mode specifies the behavior of the backlight brightness after both
dimmer buttons are pressed at the same time for one second or longer, in one of
the following ways:
• none (no change in brightness)
• darkest (0)
• brightest (255)
• default brightness
• last SCOM brightness, set by the latest received SCOM brightness command
When last SCOM is specified, the brightness is set to the same value as last received
SCOM brightness command did. It is useful if meanwhile the brightness was
changed to another value by pressing one of the dimmer buttons on the front.
Related information
Default Brightness
Beijer Electronics, MAEN986C 12