AZEK Bullnose Paver & Transition Paver - Manual (Page 2)

Page 2
Installing AZEK Resurfacing Bullnose Pavers
LEAVE 6.5"-7" OF
GRID REMAINING
4X8 PAVERS IN
DESIRED PATTERN
SUB-STRUCTURE
BULLNOSE PAVER
GRID
APPLY ADHESIVE
SCREW TABS
BULLNOSE PAVER TO BE FULLY
SUPPORTED BY SUB-STRUCTURE
BULLNOSE PAVER
SUB-STRUCTURE
GRID
LEAVE 6.5"-7" OF
GRID REMAINING
LEAVE 6.5"-7" OF
GRID REMAINING
45°
SUB-STRUCTURE
BULLNOSE PAVER
4X8 PAVERS IN
DESIRED PATTERN
SCREW TAB
APPLY ADHESIVE
GRID
CUT BULLNOSE
PAVER 1 AS SHOWN
CUT BULLNOSE
PAVER 2 AS SHOWN
CUT BULLNOSE PAVER 4 AS SHOWN CUT BULLNOSE PAVER 3 AS SHOWN
BULLNOSE PAVER TO BE FULLY
SUPPORTED BY SUB-STRUCTURE
BULLNOSE PAVER
SUB-STRUCTURE
GRID
Resurfacing Bullnose Pavers
LEAVE 6.5"-7" OF
GRID REMAINING
4X8 PAVERS IN
DESIRED PATTERN
SUB-STRUCTURE
BULLNOSE PAVER
GRID
APPLY ADHESIVE
SCREW TABS
BULLNOSE PAVER TO BE FULLY
SUPPORTED BY SUB-STRUCTURE
BULLNOSE PAVER
SUB-STRUCTURE
GRID
LEAVE 6.5"-7" OF
GRID REMAINING
LEAVE 6.5"-7" OF
GRID REMAINING
45°
SUB-STRUCTURE
BULLNOSE PAVER
4X8 PAVERS IN
DESIRED PATTERN
SCREW TAB
APPLY ADHESIVE
GRID
CUT BULLNOSE
PAVER 1 AS SHOWN
CUT BULLNOSE
PAVER 2 AS SHOWN
CUT BULLNOSE PAVER 4 AS SHOWN CUT BULLNOSE PAVER 3 AS SHOWN
BULLNOSE PAVER TO BE FULLY
SUPPORTED BY SUB-STRUCTURE
BULLNOSE PAVER
SUB-STRUCTURE
GRID
Resurfacing Bullnose Pavers
• Cut Grid to allow for adequate interaction
of Grid and Paver and so the bottom of the
Bullnose Paver is fully supported.
• Choose a starting point based on the dimensions of the project and the desired pattern.
• Fasten Grids on stair treads using 1.5" screws.
• Do not fasten grids on deck or flat roof surfaces.
• Apply 1/4" bead of adhesive to the top ribs of the Grid.
(Titebond PROvantage Landscape Adhesive is recommended).
• Place Bullnose Paver onto the Grid, pressing firmly.
• Screw down the visible tabs into the Grid.
• Do not screw into deck boards except on stairs.
•
Screws are not recommended on flat roof applications.
• Slide adjacent Bullnose Pavers into place until finished.
(May need to cut off exterior tabs)
• Let cure for a minimum of 72 hours.
Corner Assembly