Acer Altos G300 Series - Manual (Page 141)

129
84h Locked key checking is over. Checking for a
memory size mismatch with CMOS RAM data next.
85h The memory size check is done. Displaying a soft
error and checking for a password or bypassing
WINBIOS Setup next.
86h The password was checked. Performing any
required programming before WINBIOS Setup
next.
87h The programming before WINBIOS Setup has
completed. Uncompressing the WINBIOS Setup
code and executing the AMIBIOS Setup or WINBIOS
Setup utility next.
88h Returned from WINBIOS Setup and cleared the
screen. Performing any necessary programming
after WINBIOS Setup next.
89h The programming after WINBIOS Setup has
completed. Displaying the power on screen
message next.
8Bh The first screen message has been displayed. The
message is displayed. Performing the PS/
2 mouse check and extended BIOS data area
allocation check next.
8Ch Programming the WINBIOS Setup options next.
8Dh The WINBIOS Setup options are programmed.
Resetting the hard disk controller next.
8Fh The hard disk controller has been reset.
Configuring the floppy drive controller next.
91h The floppy drive controller has been configured.
Configuring the hard disk drive controller next.
95h Initializing the bus option ROMs from C800 next.
See page 131 for additional information.
96h Initializing before passing control to the adaptor
ROM at C800.
Checkpoint Code Description
aa300.book Page 129 Tuesday, December 17, 2002 5:27 PM