Vaddio WallVIEW HD-22 and HD-30 DVI-HDMI - Manual (Page 12)

WallVIEW HD-22 and HD-30 SR Systems
WallVIEW HD-22 and HD-30 DVI/HDMI SR Cameras Systems - Document Number 342-0644 Rev A Page 12 of 24
Boot Order Notes: When using a joystick controller or external control system, in order to
ensure proper continuity of camera control, the RS-232 controller should be powered-on after
the camera. In most, if not all cases, the camera needs to be on and running in order for
communication to take place between the camera and controller. When plugging a new
camera into a RS-232 controller/joystick that has already been powered up, a system reboot
or camera rescan may be necessary to find the camera.
Image: Basic Connectivity Example of the HD-22 or HD-30
Camera Connected to Quick-Connect SR Interface, ProductionVIEW™ Precision Camera Controller and Monitor
.
Rear View of HD-22 or
HD-30 PTZ Camera
RS-232
Cat-5
RS-232
Cat-5
HD Video
and Power
Cat-5
Video, Power and Control on two
Cat-5 cables up to 100’ (30.48m)
HD Video
YPbPr
24VDC, 2.0 A
Power Supply
HD Monitor (Simulated Video)
← Video
Power
→
Quick-Connect
DVI/HDMI SR
Interface - Rear
Panel View
ProductionVIEW™
Precision Camera Controller
Two (2) Cat-5
Cables between
Camera and the
Quick-Connect SR
CONCEAL Mount
Not Shown
* HD Video HDMI
(w/cable adapter)
HD MV Multi-Viewer Monitor
and Console (not shown)
Simulated Video Feed
* The Recessed Color Space
Conversion Switch enables the
use of either HDMI (YCbCr) or
DVI-D (sRGB) color space for
added flexibility.