Vaddio Indoor Pendant Mount Dome - Manual (Page 4)

DomeVIEW HD - 12” Indoor Pendant Mount Dome
DomeVIEW HD - 12” Indoor Pendant Mount Dome Manual 342-0187 Rev. A Page 4 of 8
Anatomy of the 12” Indoor Pendant Mount Dome
The DomeVIEW HD Indoor Pendant Mount Dome Enclosure will come partially assembled.
• 1.5” NPT Pipe Flange: Fits 1.5” NPT pipe or wall
mount kit with 1.5” NPT male threads *
• Rubber gasket to seal between pipe flange
and plastic shroud *
• UV protected plastic
shroud with drip edge *
• Three (3) 10-32 x .5” pan head screws attach
through back of metal back can to the 2.5”
stand-offs
*
• Four (4) ¼’-20 Keps Nuts secure the 1.5” NPT
pipe flange to the enclosure *
• Sealed metal back can with weather
stripping sealer around flange *
• Three (3) 2.5” long 10-32 threaded F to F .5” Hex
stand-offs support the camera platform *
• Two ¼”-20 x 5/8” screws attach HD-18 camera to platform
• Two ¼”-20 x 3/8” screws attach HD-20 camera to platform
• Three (3) .75” long 10-32 threaded
M to F .5” Hex stand-off extensions
Use with HD-20 Camera Only
• Universal Camera Platform
• Three (3) 10-32 x .5” Pan Head Screws
attach through the camera platform to the
2.5” stand-offs
*
• Vaddio HD-20 or HD-18 PTZ Camera
• 12” Smoke tinted dome with three (3)
stainless steel screws attached
* These parts are pre-assembled.
Not Assembled
Not Assembled
Not Assembled