Power Soak 31990 PS-100 Owner's Manual - Manual (Page 22)

18
Facility Owner/Manager Section
The only troubleshooting procedure that the facility
owner or manager can perform is listed immediately
below. All other procedures must be performed by an
authorized service agency. To obtain the name of a
recommended service agent in your area, please call
the Power Soak Service Department at (816) 222-
2400.
Wash Pump Will Not Operate
Refer to the following troubleshooting guidelines:

Check to make sure the main electrical power breaker for the Power
Soak system is in the “ON” position.

Check to make sure the wash sink is filled to the waterline.

Check to make sure that the liquid level sensors are clean and free
of any debris or grease. The liquid level sensors are located on the
side walls of the wash (the white plastic disc with a metal center).
If the above trouble shooting procedures do not correct the problem, you
must contact Power Soak Systems, Inc., or an authorized service agency
at (816)222-2400.